Fellenius Releases wave Equation

I remember the 1983 conference and this "DFI News" note with its summary of my lecture - and how I cringed on seeing the heading of the note, claiming that I had "released the wave equation." The WEAP (wave equation analysis of pile driving) had been "released" about a decade earlier by the founders of GRL Engineers and Pile Dynamics, George Goble and Frank Rausche, marking the beginning of their great contributions to the geotechnical engineering practice "the quantum leap." I appreciate the opportunity, now 40 years later, to correct the heading implication. Several typos in the note, then irritating, are now more amusing, such as, "dull complex" instead of "full" and "restriction" instead of "restrike." My lecture tried to introduce some of the then recently developed dynamic monitoring and analysis state of the practice: the WEAP and PDA/CAPWAP (Pile Driving Analyzer/CAse Pile Wave Analysis Program). The lecture and the notes should be read in the light of how they were operated in early years. The mainframe computer and input was by means of punch cards. The field testing using the PDA was by lugging the analyzer, a bulky tape recorder, an oscilloscope, and power-cable and gage-chord bundles to the site. If travel was by air, the analyzer sat on the seat next to the engineer. For assessing the pile in the field, the measurements were printed out on a paper roll. In the mid-1980s, a screen was added to the analyzer, it became digital, and data were stored and accessible electroni- cally also in the field. No more tape recorder and oscilloscope. At about the same time, the PC arrived and the WEAP became available for running on the office machine. Process was slow; while the PC ran a WEAP, it was time for a cigarette and a cup of coffee. To think through the input to the analysis, there- fore, became an important time-saving effort. Soon thereafter, the CAPWAP also became available for use on a PC. The first International Stress Wave Conference in Stockholm in 1980 (it continued every fourth year, thereafter) started the international acceptance of monitoring. At the third conference, in Ottawa in 1988, the number of indi- viduals outside of GRL performing CAPWAP analysis amounted to 17, with 14 from outside the U.S. Today, the high-strain dynamic monitoring is routine wherever piles are driven, and its use has been extended to testing non-driven piles. The wave equation and high-strain dynamic method, then and now, is for assessing pile-soil response in terms of pile capacity and hammer perfor- mance. Over the years since, it has been extended to low-strain integrity testing and current advancement of tech- nology has been incorporated. For example, the connection between pile gages is now wireless and the analyzer is a tablet. The pile monitoring data can be sent to the "cloud" and enable remote testing. The process is so fast that an automatic signal matching can be made in real time on every blow. At some sites, every pile is tested, thus, the method is used for continuous quality control of the hammer-pile-soil system.