Florida Paper - The Lixiviation of Silver-Ores by the Russell Process at Aspen, Colorado (see Discussion p. 993)

The purpose of this paper is to record the results obtained in the use of the Russell process at Aspen, Colo., covering a period of fourteen months, from November, 1891, to December, 1892, during which time over 30,000 tons of ore, purchased outright, on sample and assay, were treated. No explanation of results will be attempted, nor will the chemistry of the process be discussed. The plant was designed by C. A. Stetefeldt, of San Francisco, and built by the owners by day-labor. The entire plant is run by water-power, supplied by a flume 3600 feet long, and a pipe-line 2200 feet long, with a head of 170 feet. A Pelton water-wheel, 8 feet in diameter, is used, from which power is transmitted by wire-rope to the main counter-shaft in the mill, a distance of about 250 feet. From the mill to the samplingworks, about 150 feet, power is also transmitted by a wirerope. A Pelton water-wheel, 3 feet in diameter, supplies power to the dynamo for lighting the plant. The works are located adjoining the Santa Fe railroad tracks, and all ore and supplies are unloaded directly from the cars to the works. The sampling-works are provided with crushers and rolls, the latter being used only on samples, and not on the entire ore. The Cornish hand-quartering method is used in sampling ore for purchase. After crushing and sampling, the ore goes to the bedding-floor, where it is made up into mixtures suitable for the mill. The drying-plant consists of four Stetefeldt double shelfdryers, six shelves high, and is provided with dust-chambers and a stack 65 feet high for draft. These dryers are fired with gas