IC 9062 Microcomputer-Based Instrumentation System For Monitoring Ground Support In A Deep Mine Shaft

The National Institute for Occupational Safety and Health (NIOSH)
J. K. Whyatt
Organization:
The National Institute for Occupational Safety and Health (NIOSH)
Pages:
93
File Size:
30817 KB
Publication Date:
Jan 1, 1986

Abstract

This report describes a microcomputer-based instrumentation system for structural monitoring of the circular, concrete-lined Silver Shaft in northern Idaho, The 1-ft-thick concrete lining and surrounding rock mass were instrumented with a total of 12 multiple-point borehole extensometers, 16 pressure cells, 22 concrete embedment strain gauges, and 12 thermistors. The instruments were distributed among four test sites and installed immediately above the shaft bottom during sinking at the 2,414, 4,063, 5,191, and 5,955 levels. Limited access to the instruments prompted the development of a microcomputer-based remote data acquisition system that could be operated from the surface. The system scanned the instruments on a programmed schedule, printed out reduced data, and stored the data for plotting and recall. Data acquisition from off-site and uploading of data to mainframe computers were accomplished by the addition of modems to the basic system. The system is suitable for use in monitoring the structural behavior of any deep mine opening, especially in harsh operating environments and where access is limited.
Citation

APA: J. K. Whyatt  (1986)  IC 9062 Microcomputer-Based Instrumentation System For Monitoring Ground Support In A Deep Mine Shaft

MLA: J. K. Whyatt IC 9062 Microcomputer-Based Instrumentation System For Monitoring Ground Support In A Deep Mine Shaft. The National Institute for Occupational Safety and Health (NIOSH), 1986.

Export
Purchase this Article for $25.00

Create a Guest account to purchase this file
- or -
Log in to your existing Guest account