Metallurgical Aspects of the Use of Nickel in Galvanising

The zinc-nickel alloy process, TECHNIGALVA, was developed for the control of the thicknesses of zinc -coatings on reactive silicon-killed steels. These are steels containing between 0.04 and 0.15 per cent silicon which have become more common in recent years as more steel is produced by continuous casting. The introduction to this paper will review the current status of this process in Europe, North America and Australasia. It is well known that the presence of silicon at certain levels in steel can cause sufficient growth of intermetallic phases during galvanising to form a grey coating of excessive thickness. This type of coating is undesirable because it is brittle and has poor adhesion to the steel base. Since the early-1980s a widely accepted practice for suppressing the reactivity of steels containing silicon during general galvanising has been the addition of approximately 0.1 mass per cent nickel to the galvanising bath ie the TECHNIGALVA process. The paper will also discuss metallurgical aspects of the use of nickel in galvanising such as the mechanisms by which nickel suppresses reactivity, the structure and composition of the ternary Zn-Fe-Ni drosses formed when using nickel and the use of nickel in the galvanising bath at a level of about 500 ppm to give thinner, smoother and brighter coatings on steel.