Mexican Paper - A Crystalline Sulphide in Pig-Iron

It is now well known that certain pig-irons give a considerably smaller percentage of sulphur when determined by evolution-methods than when determined by oxidation-methods. The most striking examplcs of such irons are those made either wholly or in large part from New Jersey magnetites containing more or less titanium. It is never safe to use an evolution-method on such iron; for it is quite common that the sulphur result by evolution is only one-half or even one-third as great as that obtained by oxidation. For this reason, evolution-methods should be discarded, except in the analysis of pig-irons known to contain the sulphur in a state of combination from which it is evolved as sulphuretted hydrogen on treatment with hydrochloric acid. A good example of an iron containing, in the residue, sulphur insoluble in hydrochloric acid having come to our attention, it was determined to try to isolate a suspected insoluble sulphide. A large piece of high-silicon gray-forge iron was accordingly selected as the most promising material to work on. This piece was dissolved slowly, through several months, in dilute hydrochloric acid, aided by the electric current, yielding a soft graphitic residue. The object of dissolving a mass of iron, instead of drillings, was to prevent the crushing, by the drill, of any insoluble crystalline compound that might be present. The first step in the preparation was to break up the graphitic material and put it through bolting-cloth of 157 meshes to the linear inch. This was done by crushing the mass under the fingers on the bolting-cloth fastened over the top of a beaker, while a stream of water from a wash-bottle washed the finer portions through the cloth. The suspended matter was allowed to settle. It was then transferred to a platinum