Papers - Increasing the Extraction of Oil - Repress ring in the Selover Zonc at Seal Beach and the Effect of Proration (With Discussion)

RepressuRIng, or gas drive, was first tried in the Seal Beach oil field during the fall of 1927, and was carried on until the spring of 1928. This experiment in the Upper or Bixby zone was highly successful in proving the feasibility of compressing gas to high pressures and also showed great increases in production. The project was discontinued because there were not enough wells to protect the property lines. In the development of the second or Selover zone, many more wells were drilled and after 2½ years of production the gas was depleted so that all producing wells in the zone were either pumping or on gas-lift. Edge-wat'er encroachment and the deepening of wells on neighboring properties to a third zone practically isolated the lease, so that during the spring of 1929 it was considered feasible to repressure the Selover zone on the Bixby lease of the Continental Oil Co. (Marland). As shown on Fig. 1, the main Seal Beach structure is an elongated dome with a northwest-southeast trend, and the north flank is cut by a fault nearly parallel to the axis of the structure. Bixby well No. 24 was chosen for the injection well on account of its location, as it is backed up by the fault and is surrounded by wells that protect the property lines. The results of the test made in the Bixby zone indicated that an injection well on the flanks of the structure would drive oil quickly to up-structure wells but would have a tendency to cause by-passing, while the drive to down-structure wells would be slower but more evenly distributed. Preferably the injection well would have been located on top of the dome but property divisions made this inadvisable. Well 24 had been completed in November, 1928, but on account of gas depletion the well failed to flow naturally. On gas-lift the well had an initial production of 1000 bbl. of oil with 30 per cent. emulsion. This well is 4825 ft, deep, penetrating 200 ft. of oil-bearing formation. At the time the well was prepared