Production Engineering - Recent Developments Related to Petroleum Engineering

Recent developments related to petroleum engineering discussed in this paper are: 1. Drilling wells in with oil or the use of chemical compounds or (Imud solvents" for removing rotary mud from wells in order to increase or make possible oil production. 2. Comparison of results of electrical logging methods in locating water, as shown in a recent test on a well in the Los Angeles Basin. 3. A new method for logging formations through casing, known as the Stratagraph. Drilling Wells in with Oil or the Use of Chemical Compounds or Mud Solvents During the time that the California fields showed high gas pressures, the pressure of the gas within the formation was sufficiently great to break down the mud wall or cake formed while the well was drilling. That this did not always occur was demonstrated by the fact that in some of the older fields new wells sometimes had substantially higher initial productions than other wells near by. The explanation seemed to be that some sands were mudded off in the original drilling. Their pressure was then not great enough to break down the mud wall in competition with the higher pressure of the sands, but the situation reversed itself so that a later well benefited by the pressure in these originally weaker sands. As time passed, in wells deeper than 5000 ft. the difficulty of bringing wells on production became more pronounced. This led to a hunt for substitutes, of which a number have been tried. The one that has proved most successful in our experience at Ventura is known as the Nobs solvent. At well No. 1 of the Associated-Ventura Land & Water Co. when it was recompleted in February 1936, about 10 days were spent in trying to bring the well in in the regular manner, but only about 113 bbl. of water could be swabbed from the well, and even this quantity decreased as time passed. The Nobs solvent was spotted in the bottom of the hole opposite the perforations, inverted Guiberson swab rubbers were used on the drillpipe and the hole was down-swabbed in stages, beginning