Technical Papers and Discussions - Copper and Copper-rich Alloys - Structure after Working - The Nature of Strain Markings in Alpha Brass (Metals Tech., Feb. 1948, TP 2327) With discussion

- Organization:
- The American Institute of Mining, Metallurgical, and Petroleum Engineers
- Pages:
- 20
- File Size:
- 2730 KB
- Publication Date:
- Jan 1, 1949
Abstract
The fine lines shown in Fig I are typical of markings that ma): be detected after polishing and etching deformed specimens of alpha brass and other alloys. Although they have long been the subject of discussion by metallurgists their nature is still uncertain and the names that have been applied: to them, such as deformation line4 or strain markinas, indicate this uncertainky. In this paper which repotts the results of a furthcr investigatinn of their nature, they will be called strain mxrkings. Introduction Mathewson and Phillips1 described strain markinps in 1 916 and concluded that they appear only after 20 pet deformation. They objected to the markings being called slip tines believing this term should be sewrved for surface markings protluced by plastic deformntion. In 1921. vogel² described similar striations which appeared after polishing and etching the roughly ground surface of numerous alloys. He reported that the markings were crystallo-graphic in nature, and since they resemble Seumann hands in iron, at least superficially, he assumed them to be mechanical twins. In 1928, Matherwson reported work by Phillips which indicated that the lines were more readily produced by impact than by slow deformation and that in many cases the twins inside recrystallized grains were parallel to strain markings in the original deformed grains. This was taken as cvirlence that the markings coalesce into anncaling twins. and hence that they themselves are mechanical twins. Many attempts have been made to demonstrate directly that the markings are mechanical twins. In 1934, Samans described the results of X ray studies of two defomed crystals of alpha brass. Evidence was obtained which could be interpreted to indicate that the strain markings arc mechanical twins, and this remains the only direct evidence to this effect. Several other attempts to obtain similar evidence by X ray diffraction have failed5.8.7 although in no Ease was the original method of Samans employed. An
Citation
APA:
(1949) Technical Papers and Discussions - Copper and Copper-rich Alloys - Structure after Working - The Nature of Strain Markings in Alpha Brass (Metals Tech., Feb. 1948, TP 2327) With discussionMLA: Technical Papers and Discussions - Copper and Copper-rich Alloys - Structure after Working - The Nature of Strain Markings in Alpha Brass (Metals Tech., Feb. 1948, TP 2327) With discussion. The American Institute of Mining, Metallurgical, and Petroleum Engineers, 1949.