The Nature and Origin of the Gold-Bearing Laterities at Mount Gibson, Western Australia

The Mount Gibson goidmine is located at the southern end of the Retaliation greenstone belt within the Murchison Province, approximately 300 km northeast of Perth, Western Australia. Economic gold mineralization occurs in the upper part of a Tertiary lateritic surface; its ultimate source presumably being Archaean greenstones. Gold is present in the laterite profile over a distance of 4 km in four separate prospects, from north to south, Mount Gibson Well, Midway, Orion and Tobias Find, the two last constituting the Mount Gibson mine. The area has'low relief. A low ridge to the west of the mineralized zone is formed mainly of rubble with minor outcrops of mafic volcanic and intrusive rocks. The terrain slopes gently to the northeast, and the maximum relief, in the vicinity of the mineralization, is about 20 m. The weathering profile comprises, from the surface: (i) soil, windblown sand or colluvium (thin), (ii) laterite; hardcap (including ferricrete and lesser silcrete and calcrete) is overlain by loose nodules and pisolites, and passes downwards into a mottled zone of variably ferruginized clay, (iii) clay; mainly pale brown, cream or yellow in colour, but in places contains relic quartz veins or dark ferruginous zones, (iv) clay with fragments of altered rock; normally grey to pale green in colour but sometimes includes an oxidized iron-rich horizon just above the weathered/fresh rock interface, (v) bedrock. The complete profile varies from 10-100 m thick, averaging 20 m. Zone (ii) is commonly 3-5 m thick. Loose pisolites of this zone fill cavities in the massive ironstone left by former tree roots, and cover irregular depressions which may represent former stream courses. Samples, representing 3 m intervals down the holes, have been collected from cuttings taken from rotary drill-holes along each of four traverses; one traverse at each-of the northern prospects and two traverses in the Orion part of the mine area. These samples have been submitted for X-ray diffraction analysis and for chemical analysis for a wide range of elements. Bedrock lithologies have been determined from microscope studies of bottom-of-hole chips.