Search Documents

By Morrison K

This paper describes an approach developed by the authors for integrating social and environmental impact assessment (SIA and EIA) for mining projects. The approach is an evolving one and is based on experience gained over the past five years undertaking environmental and social impact assessment for a range of mining and other projects. The approach described is an attempt to systematise the various steps undertaken in impact assessment and the means of integration of the two approaches.

Jan 1, 1987

The coking coal produced by Utah Development Company in the Bowen Basin is processed by a dual system of dense media cyclones for the 30mm x 0.5mm feed and flotation for 0.5 x 0mm material. The basic metallurgy of these processes will be presented with emphasis on the operational characteristics which are peculiar to coal. Potential areas for process improvement by the application of more sophisticated control systems will also be discussed.

Jan 1, 1978

THIS instrument, depends on the principle that, over a short period, the surfaee of a porous substance from which a liquid is evaporating receives the same amount of heat by conduction, convection, and radiation as it loses in the latent heat of the evaporating liquid. If, then, the amount of heat being received by a surface can be measured, the rate of evaporation can also be obtained. The Kata thermometer is also based on this principle differently applied.The instrument, as shown in Fig. 1, consists essentially of a thermometer with a sliding which is divided by three pointers into two equal parts which may be spaced so as to cover a distance of, for example, 5° of the thermometer scale. The instrument is calibrated so that the amount of heat required per unit area of the bulb to raise the menissus is known. The method of using the instrument is as follows:The slide is first set so that thc central pointer is at the temperature of the evaporating surface.The thermometer is cooled by any convenient means so that the meniscus is several below the lowest pointer. The thermometer is then placed near the evaporating surface, when the Ineniscus begins to rise and the time taken for it to rise from the lowest to the top pointer is measured. From this and the calibration results the amount of heat retained per unit area of the bulb at the mean temperature...

Jan 1, 1928

By C Aldrich

In this paper, the use of topology preserving projections (Sammon maps) and neural networks are considered as a basis for the construction of multivariate statistical process control charts for a semi-autogenous grinding circuit on a gold plant. Comminution circuits are often operated in a quasi-steady state mode, where the mills tend to move rapidly from one state to another. This makes them difficult to monitor by conventional means designed for continuous steady state processes. As a first step, process data reflecting normal operating conditions are mapped with SammonÆs algorithm. Only one feature is extracted at a time and each mapping is captured by a neural network model to allow online application. Reverse neural network models are used to reconstruct the data prior to the extraction of subsequent features from the data residuals. The ensemble of neural network models can then be used for both fault detection and identification. The approach compared favourable with both linear and non-linear principal component models. It was able to detect two simulated fault conditions both with a reliability of 100 per cent, as opposed to 57.8 per cent and 95.2 per cent detected by an approach based on the use of linear principal component analysis and 84.1 per cent and 98.0 per cent detected by an approach based on non-linear principal components extracted with auto-associative neural networks.

Jan 1, 2007

By D Cai, E Baafi

Various enabling technologies and systems have recently been introduced in the mining industry. Such systems include miner-bolters with concurrent cutting and bolting, employment of two shuttle cars, adoption of self drilling bolts and utilisation of continuous haulage or monorail systems. The paper discusses how Flexsim discrete event simulation models were used to assess how these proposed mining systems can best be used to achieve and sustain high roadway development rates of 10 m per operating hour for 20 h/day.

Sep 26, 2011

By Willett, Jacka

Group 3 were asked to discuss the treatment of spontaneous combustion. Before discussing specific cases we agreed that certain preliminary information should be available. The following questions are typical of the information which might be requested: 1. Have workmen been withdrawn? 2. Have gas samples been taken? 3. Is the mine gassy? 4. What are the details of water supply? 5. Are mine plans available? 6. What equipment is available? We discussed treatment in four different circumstances as follows: 1.

Jan 1, 1973

Mining engineering, metallurgy and minerals-related geology have proud traditions and are essential professions to support a safe and sustainable minerals industry. However, the future of these professions is under threat. The courses that produce such graduates are disappearing worldwide and the number of graduates available to enter the industry has been falling in English speaking countries for at least a decade. It is unlikely that this problem will be remedied by æsupply and demandÆ. Instead, some active intervention is required.

Jan 1, 2004

By Aspinall T. O

This paper discusses the identification and assessment of risk for mining developments particularly for open pit mining. A distinction between sensitivity studies and risk analysis is developed, demonstrating the importance of geological and mining engineering judgement -as applied by experienced practitioners to the analysis and assessment of risk in such projects. Technical and financial risk analysis are discussed under: ò mineral resources and ore reserves; ò mining and processing methods; ò project construction; ò financing; and ò costs and commodity pricing predictions.

Jan 1, 1994

A geologic, petrographic and geochemical study has been performed on the pyroclastic flow deposits in the coastal area of East Zhejiang Province, Southeast China. This study leads to classification of the pyroclastic flow deposits into three associations: the extrusive type, the surge type and the ash flow type welded tuff associations. Through detailed investigation and comparison of the characteristics of these lithologic associations, with emphasis on the welded tuffs, a comprehensive model has been proposed to demonstrate the petrogenesis of the pyroclastic flow deposits.

Jan 1, 1995

In submitting the accompanying sketch and description, the writer mentions that he has found this "gadget" a useful assay office adjunct.He believes that some millmen and assayers have been confronted, from time to time, with large samples of mill pulp for assay purposes and that although the commonly used method of coning and quartering dry sample is simple and effective, provided the samples are of reasonable proportion, the operator is frequently confronted with samples of pulp, sometimes up to 50 gallons. The writer stresses the advantage of being able to handle these samples. This fact inspired the design of the "gadget,"which was developed at the Kalgoorlie State Battery and has been found to give very reliable results. It has considerably eased the work of the assay office.Description. - A cone of suitable dimensions according to requirements (this one is about six gallons' capacity) is mounted on a light angle-iron frame and has a small hand-operated agitator paddle let into it far mixing purposes. The agitator and head frame are removable to facilitate cleaning. Four outlet pipes at the bottom at right angles to each other are controlled with one common plug, externally operated for discharging the pulp.Each operation of the machine delivers four equal parts; one or more of these can be used for further division as conditions require. Samples can thus be reduced to suitable assay room size in a few minutes.The dotted lines, enclosing the shaded portion, represent the four-bladed paddle.Each paddle is slotted with three parallel slots. Unshaded portions represent slots.

Jan 1, 1939

By S Cossfo Torres

Minera PenmontÆs gold mine, La Herradura, is located at the northwestern Mexican state of Sonora and consists of an open pit mine and heap leaching facility for the recovery of gold. The production began in July 1998, and today La Herradura produces about 200 000 oz of gold per year. Standard sampling and assaying protocols were established during exploration based on heterogeneity tests. However, at deeper zones of the pit, coarse gold became evident and it was necessary to develop a new sampling protocol in order to minimise the fundamental error and improve the metallurgical accounting. This new sampling protocol requires cyanide leaching the whole pulverised sample from the blasthole, assaying pregnant solution and fire assaying 50 g of tailings. A sampling study was performed on 195 blasthole samples analysing gold under the standard and new protocols. The new protocol demonstrated that the original one underestimated gold grade by approximately 27 per cent, with impacts on ore misclassification and metallurgical accounting. According to the ore grade control system, mineral with gold grade above 0.35 g/t was sent to the leach pad and mineral with lower grade was classified as waste. Based on the sampling study, it was decided to classify a low-grade ore with gold assay between 0.20 and 0.35 g/t which was stored for future treatment under better gold prices or should mine production decrease. These two conditions were present during 2005 and 2006, when about 3.5 Mt of low-grade ore were leached.

Jan 1, 2008

Mine Dewatering for reoccupation of a flooded mine requires rehabilitation and recommissioning of shaft and sane level functions to provide safe efficient access, services and logistics, as well as securing connections with all exposed workings. The objective is the earliest secure reoccupation of the target depth horizon for minimum water pumping, consistent with an appropriate investment and optimum schedule of operating inputs to the dewatering, redevelopment, services and consolidation processes. Strategy must focus on recommissioning of relevant functions in the shaft and at stage pumping horizons, advance of logistics close to pumping and rehabilitation, management of the secured exposed workings. The progress must be systematic, sustained and integrated, and must be secured against risk and uncertainty. There must be a strategic capability to respond effectively, and manage interruptions to processes, conditions requiring higher or different resources, and contingencies which affect schedule, budget or risk profile for the continuing programme. Planning must aim to reduce or contain risk or uncertainty elements and contingencies, limit interruption frequency and severity, identify and provide the capability for efficient responses. It is appropriate to model and simulate the reoccupation analogous to a mine initial development production programme. Only minor changes to relationships and relativities of models for Capital works, Operations (Production and Development) and Services/Logistics are needed but the model for management of workings is more relevant than that for depleted workings in an operating mine because of the water and other transfers. An important difference is the unsteady state of operations which requires probabilistic modelling of availability and utilization of equipment and processes.

Jan 1, 1988

Traditional methods for calibrating the most customisable forms of GyÆs formula for the prediction of sampling variances involve a large amount of experimental work. This work is often extremely sensitive to outlier treatment and often relies on assumptions. A general methodology called æthe consistency methodÆ, however, has proven efficient in guiding these critical steps and adding objectivity to these subjective tasks. After a quick exposition of its principle, it is shown how it can also be used to reduce the amount of experimental work when dictated by budgets.

Jan 1, 2008

Away from past controversial presentations, a matter of fact, intuitive and simplified approach to the Theory of Sampling (TOS) sampling variance prediction formula is offered which gives an insight on the type of model required for the liberation factor, the practical limitations of such model and methodological principles for its calibration. This paper intends to see what happens in TOS when trying to go from the very simple towards the full level of real life complexity, and actually tries to answer the question: Is there such a thing as a æsimpleÆ TOS?

Jan 1, 2005

A number of forecasting methods are available to mine management to help predict the most likely outcome of some particular event thus enabling management to make more cost effective decisions. Three general classes of models can be used to predict future events qualitative, structural and time series, the most effective method in most cases being time series. Time series methods can be applied to predict future events from a series of past observations. Various time series techniques are reviewed with a comparison of their relative advantages and disadvantages.

Jan 1, 1980

By Jin C, Shu H

The effect of operating parameters of a shaking table on the separation of mixed quartz-magnetite artificial feed has been experimentally investigated by use of laboratory-scale shaking table. Based on a great number of experimental data collected, the multi-variate non-linear model of shaking table has been developed. The model allows for the calculation of the product grade and recovery. A computer model has been programmed, for inclusion in a software package for the simulation and optimisation of shaking table if the feed characteristics and the concentrate grade are given.

Jan 1, 1993

The Electricity Commission of New South Wales operates three power stations located on Lake Macquarie and Lake Munmorah. Coal for these power stations is supplied by three collieries operated by the Electricity Commission, three operated by the State Mines Control Authorityrand one privately owned. Most of the coal used in these power stations is won from the Great Northern seam which lies at depths of up to 220 ft at Awaba and at depths of the order of 600 ft at the remaining mines on the southern end of the field.

Jan 1, 1972

The last 40 years has seen a dramatic reduction in the prevalence of pneumoconiosis through improved mining engineering associated with continuing medical surveillance of those at risk. Presently the dust particle count standard is being correlated with gravimetric dust standards. Chronic Bronchitis and Emphysema are also coal mining related diseases. Methane is the commonest of a number of coal mine gases. Oxygen deficiency symptoms may result from high gas content of mine air. The explosive nature of methane-air mixtures is well known. Mine gases will always present a potential threat to safety.

Jan 1, 1983

There are a number of methodologies which can be used for the preparation of environ- mental impact statements. Selection of a method depends upon the type of project and the environmental characteristics of the area where it is to be built. Most methods are satisfactory for assessing impacts on the physical environment but less so for the biological. Major problems may arise in deal ing with sociological issues because value judgements are involved. Several methods of approaching problems of this nature have been tried with some limited success.

Jan 1, 1976

By Morrison J

Considerable confusion is to be found in the methods of estimating mineral reserves. The solution appears to be more cooperation between industry and government to agree upon a classification system with guidelines to overcome the problem of the many variable factors affecting reserves. The classification system proposed by the United States Bureau of Mines and the United States Geological Survey (USBM/USGS) together with the guidelines similar to those suggested by the Australasian Institute of Mining and Metallurgy/Australian Mining Industry Council (AusIMM/AMIC) is recommended for reporting mineral reserves to government.

Jan 1, 1979