Search Documents

By J. Vaino Huhta

An exploration program which covered an area of about 17 000 km2(6564 sq miles), was carried out between 1966 and 1969 by the United Nations project named "Mineral Survey of the Azuero Area." The target became Cerro Petaquilla, Province of Colon, Panama. See Fig. 1. Regional exploration led to discoveries of many geochemical anomalies and minor mineralization, but it was only toward the end of the project that a promising target was indicated by a large zone of comer and molybdenum anomalies in stream sediments in a remote 1, area between the Cordillera and the Caribbean coast. Follow-up surveys established the presence of porphyry-type copper mineralization in the area now known as Cerro Petaquilla.

Jan 1, 1991

By M. Kaya

The main purpose of this study was to design a modular/mobile coal preparation plant with a capacity of 300 t/h for Seyitömer B3 vein (almost 70% of the whole SLI deposit). Firstly, coal washing properties and washability curves were determined by sink and float tests. Then, equipment sizing, selection, flow sheet development, economic evaluation, investment and operating costs were determined for coarse (-150+18mm), fine (-18+0.5mm) and slime (-0.5+0.1mm) coals. Economic evaluation of the proposed flow sheet showed the feasibility and profitability of the investment.

Jan 1, 2006

By R. Lee Wooten, Marco D. Boscardin, James M. Taylor

An earth pressure balance (EPB) tunnel boring machine (TBM) and pipe jacking were used to construct a 430-meter-long segment of sanitary sewer force main. The force main was constructed by first jacking a 2045-mm-outside-diameter, reinforced concrete cylinder pipe (RCCP) casing through alluvial sands and gravels. Later, a 1220-mm-diameter, ductile iron carrier pipe was installed within the casing pipe. The main concern affecting the construction method selection was the elimination of the need for dewatering, which could cause groundwater flow from deeper, contaminated sands up across a silt aquitard into cleaner, shallower sands. In addition, the method selected reduced the volume of soil to be handled and, consequentially, the potential amount of contaminated soil to be managed. Items discussed in the paper include provisions for handling boulders and controlling ground movements as excavation and jacking occurred approximately 300 mm beneath an active,4800 kPa, 254-mm-diameter natural gas transmission pipeline.

Jan 1, 1997

By L. Mao, R. Yoon

The thin film balance (TFB) technique was used to measure the equilibrium thicknesses of the water films formed between two oil phases. The measurements were conducted with dodecane at varying concentrations of dodecylammonium chloride, pH, and electrolyte concentration. The data obtained in the present work were used to calculate the surface forces acting between the two oil phases. The calculation was carried using the Extended-DLVO theory with the surface potentials calculated from the Gibbs adsorption isotherm. The results show that oil droplets suspended in water are hydrophobic and the hydrophobicity changes with surfactant and electrolyte concentrations.

Jan 1, 2004

By Nancy C. Shaver, Alan Tapp

Leach pads of 272,000 tonnes (300,000 st) and 910,000 tonnes (1,000,000 st) with associated operating ponds have recently been constructed on sidehill locations with up to 20 percent slopes. The larger pad was designed in anticipation of ore heights up to 30 meters (100 feet). This paper describes site investigations and civil engineering design as well as construction experience associated with development of these pads. The leach pads were underlain by a double liner system consisting of 2 mm (80- mil) HDPE over compacted fine-grained tailings, with an intermediate leak detection layer. Both sand and geotextile drainage layers were used. Pad slopes were limited by the factor of safety against sliding on the HDPE liner. The sites for the facilities had been substantially disturbed by prior mining and construction activities. Natural conditions included peat layers and locally swampy ground. Site preparation included french drains to lower the water table and stripping of unsuitable subgrade materials.

Jan 1, 1987

By Dao De Xu, Heechan Cho, Mark S. Klima

A study was conducted to determine the feasibility of using dense-medium centrifugation for separating fine (-150 µm) coal. A centrifuge provides the capability of varying the rotational speed and retention time independently, which offers the potential for a higher degree of control as compared to a dense-medium cyclone. Tests were conducted with a 140-mm diameter by 76-mm long Plexiglas separator, which was fitted with appropriate feed and discharge pipes to allow continuous separations to be made. A suspension of ultrafine (-10 µm) magnetite and water was used as the dense medium. The effects of operating conditions, including the magnitude of the 'g"-force and retention time, on centrifuge performance were investigated.

Jan 1, 1995

By Tanya Arsh, Thomas P. Kwiatkowski, Heather Marsh, Barry Doyle

The Big Walnut Sanitary Trunk Sewer Extension Project consists of two segments, the first a 10' excavated diameter tunnel in rock through the gas producing Ohio Shale formation and the second will be microtunneled through unconsolidated water-bearing deposits. Relatively large quantities of methane gas have been encountered in the Ohio Shale. In the softground segment, the sands and gravels contain large water storage capacity and contain shallow residential wells. This paper will present an evaluation of potential gas inflows in the rock tunnel, design considerations for contract documents preparation to inform bidders as to the volumes of gases which may been countered and design options for construction of an impermeable shaft excavation support system to insure residential wells remain in service.

Jan 1, 2001

By R. L. Guerguerian

Critical fasteners are described as they apply to the specification, manufacture and assembly on large grinding mill bolted joints. The importance of adequate design methods, related joint diagrams and pivot analyses, with special emphasis on the quality of manufacturing and the tightening of procedures in the field, are discussed in an effort to ensure high availability plant operation.

Jan 1, 2003

A roof rating system has been devel¬oped for upper seam damage prediction during mul¬ti-seam mining based on structural and geologic conditions in the upper seam. Two primary consid¬erations -geologic and spatial - form the basis of the classification system. It includes factors commonly found in geomechanics classification systems as well as factors which are peculiar to multi-seam mining, such as those which define the two adjacent seams and the innerburden. This rating system has been applied to numerous case studies to form empirical relationships for quan-titatively predicting potential upper seam damage based on anticipated subsidence and strain values and vertical movements.

Jan 1, 1988

By J. C. Danza Errico

The bauxite deposits on the Pocos de Caldas Plateau in the state of Minas Gerais, Brazil, were formed by the differential weathering and leaching of alcaline rocks in a ring structure. Their action on steep topography formed heterogeneous ore posture and chemical grades. Variographic analysis of several of these deposits show nested structures that are probably related to ore genesis. Kriged ore reserves estimation are presented with emphasis on the data pro cessing method that was employed. Programs were written in APL. Its intrinsic use of matrices contributed to faster programming and less computer time. In many cases looping was eliminated. The high resolution graphic resourses of APL. workspace facilitated programming of variogram analysis, fitting, and regularization. APL sub-routines are presented for variogram calculation and kriging.

Jan 1, 1986

By Mark L. Matthews

In 1978, Congress enacted Public Law 95-604, the "Uranium Mill Tailings Radiation Control Act of 1978." The Act authorizes the Department of Energy to stabilize and control the tailings from designated inactive uranium mill tailings sites in a safe and environmentally acceptable manner. DOE has established the Uranium Mill Tailings Remedial Actions (UMTRA) Project Office to implement, in cooperation with the affected States, Indian tribes and owners of the sites, remedial actions at the sites. The UMTRA Project Office has initiated efforts to perform remedial actions in accordance with EPA cleanup standards.

Jan 1, 1981

By Dan Mackie

Commissioning of a 150 tpd continuous vat leaching pilot plant at Ariel Resource's San Martin Mine began in October, 1995. Functioning of the systems proved to be as designed. Initial tri­als, however, were besieged with problems associated with clay fractions that were much higher than in the ore originally tested. Nevertheless, leach rates were good in the initial and subsequent trials. Difficulties with the viscous solutions generated by the clay fraction continued, requiring modifications to the solution collection methods and investigation of flocculant types and mixing points. Trials with deslimed ore and sand feed demon­strated continuous flow. Current modifications will be tried in late May, 1996, along with selected flocculants, with the objec­tive of leaching continuously without the need to deslime.

Jan 1, 1996

By Glenn M. Boyce, Timothy R. Coss

Microtunneling first appeared with some regularity in the United States in 1987. Until then, only Japan and Germany utilized this method of construction. Its high costs initially limited its application to special situations. The last ten years have seen the use of new pipe materials, new machines, new cutterheads, new techniques, and an average growth of30 percent each year. This paper documents the growth and changes that have occurred with microtunneling. Based on current industry practices and advances from abroad, this paper postulates what the next ten years may hold.

Jan 1, 1997

By R. A. Paul

The requirements for water inflow control for the Chicago Intercepting Sewer System are stringent. This posed special problems in grouting the bored and conventionally mined tunnels, shafts and chambers of the system. In adapting conventional grouting techniques to the specific problems encountered in the system's pilot project, numerous field procedures were developed. Careful preand post-grout testing and evaluation identified the most efficient and economical of these procedures. As an example of some of the conclusions reached during the project it was found that the mineralized groundwater in the Chicago area tended to reduce the efficiency of the grout holes, thus limiting their useful life. Pressure washing to remove natural fillings was a critical factor in achieving a permanent grout seal. The value of relatively thin lubricating grout mixes was definitely established. Although not an ideal situation, satisfactory results could be obtained by manifold grouting several grout holes simultaneously if done within specific limits of hole groutability, location and numbers. Caulking proved to be a primary controlling factor in achieving acceptable results. To achieve such a high degree of water inflow control requires close supervision by experienced personnel. "Temporary grouting as a construction expedient" produces seepage conditions which are extremely difficult to treat.

Jan 1, 1974

By D. A. Stanley, B. J. Scheiner, P. M. Brown

The Bureau of Mines (USBM), US Department of the Interior, has developed a method of dewatering clay slurries based on flocculation by high-molecular-weight polymers and water removal from the formed flocs using a trommel or hydrosieve. The exchange ion on the clays affects their dewaterability. Metal ions in solution and on the exchange sites of smectite clays are known to act as Lewis acids. Recent work has determined that these ions can be titrated with high-molecular-weight polymers. The relative acidity of the exchange ion and the basicity of the polymer determined by the new method give insight into the dewatering mechanism.

Jan 1, 1990

By S. L. Zhu, Brij M. Moudgil, J. L. Pinault

Prompt neutron activation probe (PNAP) was evaluated to determine chemical composition of phosphate rock slurry in-situ. The technique was able to precisely analyze Ca, Si and H using a 252Cf source. Direct measurement of P and Mg was not accurate due to interference by the rare earth elements associated with the Florida Phosphate Rock. The solids loading, particle size distribution and flotation reagents present in the slurry had no significant effect on the accuracy of the measurements. The technique was found to be reliable also under industrial conditions.

Jan 1, 1993

By Patrick R. Taylor

The hydrometallurgical fundamentals review did not arrive in time for publication in the May issue. Papers presented at the SME Annual Meeting, in Phoenix, AZ were available as preprints. The EPD Congress 1992 from The Metallurgical Society had several papers related to hydrometallurgy. Minerals Engineering 1992 was published in Minerals Engineering and contains several papers related to hydrometallurgy. In addition, a conference was held to honor Ernie Peters. The proceedings contains a large number of hydrometallurgy papers. Precious metals Gold extraction in the potassium cyanide-primene JMT sulfate-Xylene system was studied by Caravaca and Alguacil (Hydrometallurgy). Adams, Friedl and Wagner presented results on the mechanism of gold cyanide adsorption onto activated carbon (Hydrometallurgy). Adams also studied the adsorption of silver cyanide and used an IR method to evaluate adsorbed aurocyanide species on activated carbon (Hydrometallurgy).

Jan 1, 1993

By Mike S. Ness, Allan G. Provost

High speed drilling, mucking, and hauling equipment was used in driving approximately 2.16 km(7100 ft) of lower power tunnel in quartz diorite for the Tyee Lake Hydroelectric Project near Wrangell, Alaska. The .91 m(36 in.) guage rail mounted equipment included a Tamrock 2-boom electric/hydraulic drill jumbo, a Haggl and 8HR mucker , and 3 Hagglund 115C shuttle cars. Several other innovative techniques allowed maximum advance rates of up to 17.5 m/day(57ft/day) in the 3 m(10ft) horseshoe section. Average tunnel advance was approximately 11 m(day(35.4 ft/day). The primary difficulties preventing full utilization of the equipment potential were the operators' "learning curve", the need for complete retraining of all personnel in the new methods, and minor sections of faulted ground.

Jan 1, 1983

By J. Craynon, M. Karmis

Previous papers by the authors have presented a systems-engineering approach based on the premise that systems can only be optimized if all factors are considered and integrated into mine planning. This paper discusses the challenges inherent in optimizing the design of large-scale surface coal mining operations in Appalachia. Regulatory and permitting programs in the United States often focus on single parameters, rather than the full suite of desirable outcomes for sustainability. By utilizing geographic information system (GIS) tools to evaluate available data on environmental and social resources, the regulatory barriers which prevent operations from incorporating ecological and other sustainable development concerns into coal mine sustainability performance were identified. By analysis of the on-the-ground issues related to sustainability, the key parameters to be incorporated into an optimized coal mine design in Appalachia are discussed along with possible changes to the regulatory framework that would enhance incorporation of sustainability into coal mine design.

Jan 1, 2011

By Mary Ann Harrington Baker, John Trudnowski, Marietta Canty, Marek Zaluski

Three Sulfate-Reducing Bacteria (SRB) passive field-bioreactors were constructed at an abandoned mine site near Butte, Montana, to mitigate AMD emanating from a waste rock pile. Each SRB field-bioreactor contains chambers of an organic source, limestone, and cobbles. The field-bioreactors are configured differently to test the effect of different environmental conditions on the SRB. Preliminary observations indicate that, during start up and the first eight months of operation, the quantity of organic carbon supply significantly impacts the SRB activity. To date, the dissolved metals have been reduced significantly and the pH has increased.

Jan 1, 2000