Search Documents

The Inquiry into the 1994 accident at Moura No. 2 Colliery included in it's findings that mine escape and rescue options for persons in underground coal mines were in need of review. The Inquiry recommended the establishment of industry working groups to report to the Queensland Chief Inspector of Coal Mines on matters including escape strategy and life support for escape from mines.One of these task groups examined issues relevant to self-escape from Australian underground coal mines and formulated recommendations and guidelines in response to the terms of reference and scope.

Jan 1, 1998

The paper briefly discusses the benefits to proponents of a formal environmental assessment process. It is argued that any process should be fair, cost effective and efficient, involve all affected parties, and should identify important issues at an early stage. The paper outlines the procedure used in Victoria, and the ways in which it attempts to address the above criteria.In conclusion the paper discusses progress towards a national approach to Environmental Impact Assessment. This is currently being pursued by the Australian and New Zealand Environment and Conservation Council.

Jan 1, 1992

The Golden Cross mine is situated in a sensitive environmental setting on the North Island of New Zealand, about 150 kilometres south-east of Auckland and about 8 kilometres NW of Waihi. The mine is situated in dipping topography, with volcanic ashes making up soils, fault zones running through the area, and rainfall of about 3m per year on average. Water management is the most demanding environmental challenge on site, and a comprehensive programme has been put in place to address tailings deposition, long term tailings storage, and water treatment during and after operations.

Jan 1, 1995

In Munich's peculiar hydrogeological conditions (water bearing sand strata between layers of impermeable clay, silt or marl) are proper functioning groundwater lowering methods of decisive importance for underground construc- tion. Shield tunnelling with compressed air has al- ready proved to be successful. In view of growing application of shotcrete tunnelling it was obvious to consider the use of compressed air even here. After a preliminary research-project the first subway section "shotcrete under compressed air" was 1979 awarded in Munich and since that time five sections have been awarded, respectively completed. On the basis of the experiences meanwhile obtained reports will be given stating the frame conditions in which this new construction method can be applied. The tunnels consist of two shells. The outer ist driven by shotcrete under compressed air. In order to keep the air overpressure low, the groundwater often is previously detensioned or partially lowered. The inner shell of watertight concrete is built under atmosperic pressure.

Jan 1, 1987

By Floyd JM, Richardson P

The extension of theoretical and laboratory studies of the roasting of tantalite and cassiterite concentrates from Greenbushes Tin Limited to pilot and semi- commercial plant developments is detailed. A rotary pilot furnace was used to prove the feasibility of the process and a semi- commercial plant was constructed at Greenbushes to produce large quantities of roasted calcine. The additions and conditions of the laboratory study were employed to achieve marketable grades of calcine from the two materials. As well as producing calcines with less than 0.1% Sb, most of the tin in tantalite was recoverable to a separate fume product. Tin fumed during cassiterite roasting on a semi-commerical scale amounted to less than 1% of the tin in feed.

Jan 1, 1986

In a stipulated hard rock situation, drilling and blasting costs per tonne in open cutting or underground operations are comparable. In open cuts the drilling and blasting costs per tonne of ore are multiplied by the waste ratio.Conventional underground loading and haulage practices are so batch-oriented that the cost per tonne of ore handled is a large integral multiplier of open out costs per tonne loaded and hauled.If underground costs are to be reduced to compare favourably with open out costs then loading and hauling practices underground must be converted to a non-batch continuous system. This can be achieved by utilising gravity to control ore to mobile crushers feeding conveyors running direct to surface.

Jan 1, 1985

The paper describes the $US240 million expansion at Hudson Bay Mining and Smelting Co LimitedÆs operations in Canada. The company has been continuously producing copper and zinc from local area mines at its Flin Flon metallurgical plant since 1930. The paper details the companyÆs operational turnaround since 1995 and æThe 777 ProjectÆ which includes: two new mines, expansion and modification of the concentrators, expansion of the zinc pressure leach plant, a new zinc electrolytic cellhouse and the modifications to the copper smelter gas handling system to reduce ground level gas emissions.

Jan 1, 2000

By Sinha NH

ICI Australia and CSIRO have developed a novel process for extraction of zirconia from zircon sands. The two stage process involves a high temperature step and a wet chemical processing step. A pilot plant has been operating since November 1985 at CSIRO Division of Mineral Chemistry, Port Melbourne and construction of a full scale plant isplanned at Kwinana, WA.The plant has a high degree of flexibility and is capable of producing high purity zirconia up to about 99.99% and withinspecific particle size ranges. The products are being marketed by the joint company, 2-TECH Pty Ltd.

Jan 1, 1986

By Kellett KR

Gold Mining at the Lancefield Mine was commenced initially in 1897 and continued intermittently through to 1956 when rising costs and mine cave-in forced closure. The mine was redeveloped in 1981 and a new-oxide treatment plant commissioned, followed by a new refractory treatment plant in late 1982. Both these treatment plants are located within the Windarra Nickel Project plant area.The refractory ore is processed by fluidised bed roasting of flotation concentrates. This is carried out in two series connected reactors to maximise arsenic and sulphur eliminations and to minimise reagent consumption. For gold recovery the zinc precipitation process was initially used, to be later replaced by carbon-in-pulp.

Jan 1, 1984

Mount Isa Mines Limited has been mining silver-lead-zinc ore at Isa Mine for 60 years. Mining methods have evolved continuously, and current production rates of 4.7 Mt/yr are obtained from a combination of sublevel open stopping, cut and fill, and benching methods. In the near future, orebodies mineable by open stoping will be gradually depleted, and the relatively new benching method will be further refmed to replace cut and fill methods wherever possible.

Jan 1, 1993

This paper presents a summary of tools and methods used for geotechnical assessments and monitoring systems at block caving mines. A critical review of these tools is given based on the authorÆs experience in block caving operations. The reviewed tools include cavability prediction, fragmentation evaluation, geotechnical monitoring systems, numerical stress analysis and others. Some of these tools have been developed under certain circumstances in particular mines and experience shows that their applications under different geological and mining conditions have often been difficult. Examples from block cave mines are also utilised in this paper to illustrate the importance of the further development of these tools, whilst possible improvements on these tools are also suggested.

Jan 1, 2000

IF lead be heated with concentrated sulphuric acid two distinct actions will usually be observed. In the first, bubbles begin to be evolved more or less rapidly from the lead, and in the second, which occurs at a higher temperature than the first, hydrogen and sulphur dioxide are evolved, free sulphur is liberated, and leadsulphate is formed. The second action may be violent and usually continues till the lead is all consumed.Attempts have been made to apply these reactions, by means of a standard procedure, as a "Flash test" for the acid resisting qualities of chemical sheet lead. The purpose of this article is to comment on the best method of performing the test, on the various phenomena which may be observed during the course of it and on the interpretation of the results when obtained.PREVIOUS WORKIn 1919, Barr...

Jan 1, 1930

By Scholl EW, Ricken W

The simultaneous presence of fuel, oxygen, and of an ignition source is necessary for an explosion to arise. If one of these conditions is missing an explosion cannot take place. A continuous reduction of oxygen, often applied as a protective measure in surface plants, is not to be considered for underground mining because of possible danger to persons. Therefore, measures for avoiding explosions can only be concerned with lowering methane and coal-dust concentrations to an undangerous level and avoiding ignition sources. As these measures alone are not sufficient, additional ones have to be taken to keep the effect of an explosion as low as possible. Measures for controlling and monitoring methane are essential. Although the formation of dangerous coal dust concentration cannot be avoided it can be reduced. Dust-binding by means of hygroscopic pastes and dusting with limestone dust are effective measures to pre vent explosions.

Jan 1, 1981

By Bisshop J. P W

Maximum recovery of sulphide minerals by flotation is achieved over a limited size range. Valuable particles above and below this range have a smaller probability of being recovered. In the normal grinding-flotation operation, not all valuables are reduced to the optimum size range, and therefore sub- stantial losses occur. A significant improve- ment in the size distribution is not usually possible within the conventional circuit, and a more complex arrangement may be necessary to obtain optimum recovery of the valuable mineral. This problem is considered with refer- ence to the Mt. LyeZl concentrator. The performance of the existing circuit is dis- cussed, and it is shown that losses in recovery occur in both coarse and fine sizes. Laboratory tests indicate that regrinding the coarse particles results in an increase in recovery of up to 4%. Redistribution of plant grinding capacity to reduce initial grinding power by 6% and use this capacity to regrind coarse particles was considered. It is con- cluded that overall plant efficiency would be increased by 2% provided that overloading of the regrind mill could be avoided.

Jan 1, 1977

By Perry JH, King RL

The Bureau of Mines in cooperation with Kaiser Steel Corporation conducted two methane drainage studies in an advancing section of the Sunnyside No. I Mine where production was being severely hampered by methane emissions. A total of six horizontal aoreholes were completed during the studies to an average length of 291 meters. Total gas production from the boreholes as of December 1981 has exceeded 6,088,800 m3. Methane emissions into the section were reduced by 40 pct as a result of the first drainage system. The second drainage system is currently producing 11,328 m3/day from four Doreholes. Mining of the section and cementing of the horizontal horeholes is expected to begin within 2 Years.

Jan 1, 1982

By Thompson J

A programme of testing and evaluation has been in progress at Isa Mine for the last four years with the objectives of rationalising ground support practices, improving installation quality and increasing productivity of ground support functions.Numerous innovations have been successfully implemented. These include the introduction of swellex rockbolts as the major form of temporary support, the use of splitset rockbolts as the primary means of support for the hangingwalls of cut and fill stopes and the introduction of dowels with pumped cement for general long term support.The installation of swellex bolts has been successfully mechanised throughout the mine using Tamrock automatic rockbolters and Atlas Copco BUK 11R drilling rigs modified for this purpose.

Jan 1, 1985

By S J. Woods

As a part of Solid Energy's progressive rehabilitation of the Stockton Mine, it was determined that significant rehabilitation of the existing Mt Frederick Sidecast would be required to ensure the long-term stability of the sidecast. The goal of this rehabilitation is to reshape the existing stockpile into a more stable slope configuration, and the construction of a comprehensive stormwater collection and discharge system. The reconfigured slopes will facilitate the final revegetation of the exposed surfaces and the management of surface and groundwater discharges from the area. This paper briefly describes the specific details of the project and the significance of seismic conditions on the long-term stability of the reconfigured stockpile.

Jan 1, 2003

The development of the Australian uraniumindustry over the last decade has been subjectto socio-political controversy, but the industryis now beginning to emerge onto the world scene.The socio-political controversies which haveexisted over developing Australian uranium arediscussed and suggestions put forward as topossible changes in the relationship of themining industry to the pplitical and socialstructure of Australian Society.The rate of growth in energy consumptionis considered and on the basis of a growth rateof 3% by the year 2000 the world will beconsuming twice the amount of energy that itdoes today. It is anticipated that the growthin generation of electrical power will begreater than the growth rate fQr energy.The dominant part played by coal and nuclearpower in the generation of electrical power isdiscussed. Nuclear power at present, contributesabout 4% of the world's electricityrequirements and by the turn of the centurythis could be nearer to 30%.

Jan 1, 1981

By Croggon R

Passing a direct current through a jointed fine grained soft rock mass auses the movement of water by the process of electric-osmosis. There are other processes such as electrolysis which transport ions that interact with associated ions and can, in turn, be oxidised. This results in the dissolution products being transported towards the cathode electrode. In the cathode region the ferrous hydroxide is oxidised to ferric hydroxide %%ith consequent precipitation. The cracks and joints are current pathways, along which the ferric hydroxide is deposited. This deposition reinforces the joints and increases the shear strength. By adding calcium chloride to the anode, the rate of corrosion is increased with the concomitant increase of deposited ferric hydroxide along the joints. This, in turn, significantly increases the joint shear strength. The process is pervasive in that the current via the water paths travels through the crack and joint systems The result is that not only specific joints are reinforced but the cracks and mtciconnected voids are also reinforced.

Jan 1, 1997

By M N. Ingham

X-ray fluorescence (XRF) spectrometry has always been considered to be a comparative method of analysis. Reference materials are required to calibrate the analytical system. This paper describes the use of a set of æsyntheticÆ oxide standards, made from commercially available high purity compounds, to calibrate a spectrometer for 21 major and minor oxides. The spectrometer software uses simple methods of background correction, and a fundamental parameter method of matrix correction. Sample preparation is by fusion in 66 per cent lithium tetraborate, 34 per cent lithium metaborate. The use of synthetic standards, made from traceable compounds, brings XRF significantly closer to being a primary rather than a comparative method. Reference materials were used to validate the method described and examples of accuracy for major constituents are given using ores and other minerals. This method has successfully been used to analyse a wide variety of minerals and ores, as validation data shows. A titanium process example clearly shows the benefits of highest accuracy analysis.

Jan 1, 2008